Samyung ENC SRG-150DN Instruction Manual page 72

5) Press
frequency.
6) When a response is received, an alarm sounds and an alarm window is displayed.
If you press
displayed after the response in the upper right corner of the screen. Depending on the
response, the location information may or may not be included as follows.
<When there is no location information><When there is location information>
RECEPTION REQUEST CALL FOR LOCATION
8-4-2
INFORMATION
1) Set up an auto response
It is possible to set a function to respond automatically when receiving a request call for
location information.
➜ You can turn it ON in
※ When AUTO ACK is ON, when receiving a call request for location information, a call
response is sent without displaying the alarm sound and alarm window on the
screen, the POSITION DSC receiving screen is also not displayed.
2) Send a manual response
① There are [ACCEPT] / [REFUSE] types when sending a manual response.
※ Only REFUSE can be sent if the device does not have location information
Press the key
transmit the location information and time of the equipment.
If you press
position information and time with NO INFO. TASK is automatically completed after the
response.
to send a POSITION call, wait for the response at transmitted
the alarm window disappears and the alarm stops. It is
➜ ➜
[3.AUTO ACK POSITION: ON].
to respond with the received DSC frequency immediately and
, it responds with the received DSC frequency and transmits the
[1.DSC SETUP] ➜ [4.AUTO ACK SET]
71