Summary of Contents for Voxx Electronics Code Alarm Professional Series ca6155
Page 1
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. 2017 Voxx Electronics Corporation. All rights reserved.
Table of Contents Using Your Remote Control ..............3 Arming the Security System .............. 3 Passive Arming Bypass ..............3 Bypassing the Shock Sensor ............3 Hidden Alarm Function ..............3 Disarming the Security System ............3 Two Stage Door Unlock (optional) ............. 4 Activating Trunk Release (optional) ...........
If your system is set up for 2 step unlock, a third press of unlock will activate the audible response. *Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more than 2 seconds. 2017 Voxx Electronics Corporation. All rights reserved.
Two Stage Door Unlock (Optional) If this feature is enabled on your system, pressing the button one time will unlock only the driver’s door. Press again within three seconds to unlock the remaining doors. Activating the Trunk Release Feature (Optional) If this feature is enabled on your system, pressing and holding the button for 3 seconds will open the vehicle’s trunk or hatch.
System ARM/DISARM chirps can be toggled ON or OFF without entering the programming feature banks. Turn the ignition ON then OFF. Press and release the valet/programming button 3 times. The system will respond with 1 chirp for ON or 2 chirps for OFF. 2017 Voxx Electronics Corporation. All rights reserved.
User Selectable LED This feature will control whether the LED is ON or OFF when the system is Armed/ Locked and can be toggled ON or OFF without entering the programming feature banks. Turn the ignition ON, OFF, ON, OFF. Press and release the valet/programming button 3 times.
The system will exit remote start ready mode if any of the following occur: Open any door Open the hood or trunk (if connected) Press the brake Release the parking brake Turn the ignition ON 2017 Voxx Electronics Corporation. All rights reserved.
Remote Starting Your Vehicle To activate the remote start function, press and release the button 2 times within 2 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle to ensure it is safe to start. If all safety parameters are correct, the vehicle will start.
The unit enters Quick Stop Mode and will remain running until remote start time-out and then shut down. (Remote Start Ready Mode is NOT active) Note: Do not leave children or animals unattended in the vehicle when using the quick-stop feature. 2017 Voxx Electronics Corporation. All rights reserved.
Preheating or Precooling the Vehicle’s interior Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the vehicle, the heater or air conditioner will activate and heat or cool the vehicle’s interior to your setting. User Programmable Run Time / Run Time Extension The system has the ability to allow the user to extend the time the vehicle will be running under control of the remote start.
2 times. Release the valet button. To exit the 2 / 3 hour start up timer mode: Turn the vehicle’s Ignition ON. Activate the remote vehicle start feature using the remote control. 2017 Voxx Electronics Corporation. All rights reserved.
Operating the Daily Start Timer The system has the ability to start your vehicle based on a 24-hour countdown timer. This feature requires a two-part activation sequence. From the remote, while in range of the vehicle, pressing both the & buttons together will activate the 24 hour countdown timer (the vehicle will start 24 hours from this time).
Manual Transmission Mode not ready 7 Flashes Tach not learned / Crank Average not learned To manually enter diagnostics and view the last shutdown, turn the ignition ON and press and release the button. 2017 Voxx Electronics Corporation. All rights reserved.
Remote Control Buttons & Functions 4-Button Car Find / Lock Unlock Start Operation Method Transmitter Panic Lock Press and Release Unlock Press and Release 2 Step Unlock Press and Release 2 times Trunk Push and Hold (3 Sec) Car Finder Press and Release Panic Push and Hold (3 Sec)
The system will hold up to 4 transmitters in memory, programming a 5th transmitter will erase the oldest transmitter in memory. • Pressing the valet/override button at anytime during transmitter programming will advance to the feature bank programming. 2017 Voxx Electronics Corporation. All rights reserved.
LIMITED LIFETIME WARRANTY Applies to Code Alarm Series Control Modules, Sirens, Sensors, and Relays. Voxx Electronics Corporation (the Company) warrants to the original purchaser of this product that should this product or any part thereof, (other than transmitters) under nor-...
Page 17
2017 Voxx Electronics Corporation. All rights reserved.
Page 19
2017 Voxx Electronics Corporation. All rights reserved.
Page 20
Voxx Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Need help?
Do you have a question about the Code Alarm Professional Series ca6155 and is the answer not in the manual?
Questions and answers