Electrolux EOB9956VAX User Manual page 60

60 www.electrolux.com
Problem
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The display shows error
message "F....."
Steam and condensation
settle on the food and in
the cavity of the oven.
The appliance does not re‐
tain the water drawer after
you insert it.
Water comes out of the
water drawer after you car‐
ry it or put it inside the ap‐
pliance.
Water comes out of the
water drawer after you car‐
ry it or put it inside the ap‐
pliance.
The appliance does not re‐
tain the water drawer after
you push it on the cover.
The water drawer is diffi‐
cult to clean.
The descaling procedure is
interrupted before it finish‐
es.
The descaling procedure is
interrupted before it finish‐
es.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
Possible cause
The Child Lock is on.
The fuse is blown.
The lamp is defective.
Electronic error.
You left the dish in the
oven for too long.
You did not assemble the
lid of the water drawer cor‐
rectly.
You did not assemble the
lid of the water drawer cor‐
rectly.
You did not assemble the
wave-breaker correctly.
You did not fully press the
water drawer body.
You did not remove the lid
and the wave-breaker.
There was a power cut.
The function was stopped
by the user.
You did not fill the water
drawer to the maximum
level.
Remedy
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Contact an Authorised
Service Centre.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Assemble the lid of the wa‐
ter drawer correctly.
Assemble the lid of the wa‐
ter drawer correctly.
Assemble the wave-break‐
er in the body of the water
drawer correctly.
Insert the water drawer
body in the appliance by
pushing it until it reaches
to the end.
Refer to "Cleaning the wa‐
ter drawer".
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.