Table of Contents
Advertisement
`
HUMIDITY LEVEL & TIMER 2 DIGIT DISPLAY
The led indicator performs the following functions:
1. When the unit is plugged in, it will indicate the humidity level of the room.
2. When the UP and DOWN buttons are pressed, it will indicate the desired humidity
currently set.
3. When the timer is programmed will show the duration.
Notes: When the humidity level is outside the normal operational parameters will show LO/HI. If the ambient humidity
is lower than 20%, it will show "LO" If the ambient humidity is higher than 90%, it will show "HI"
OSC. (Oscillation function)
There are three different options for the outer louvre on the unit. It can
be set at 45 or 90 degrees, or alternatively to swing. Use the
dehumidifier at a 45-degree angle or with the swing function for Laundry
mode
UV LIGHT (Air purifier function)
To activate the UV function press the "UV" button and the indicator light
will illuminate. The Germicidal UV light will destroy germs, bacteria, fungi
improving the indoor air quality
HUMIDITY SETTING
Press the UP and DOWN buttons to select the desired relative humidity
level. The default relative humidity is 55%. When a relative humidity of
35% is selected, the compressor will not stop until the water tank is full.
NOTE: The desired humidity cannot be changed in SMART mode.
TIMER
Press the TIMER button to program the timer. When the timer is
activated, the "TIMER" light will illuminate. Before programming the timer,
ensure the timer function has not been activated (the light must be off).
The following timer programs are available.
DELAYED POWER-ON FUNCTION: With the appliance in standby,
press the TIMER button, then use the UP and DOWN buttons to set in
how many hours time you require the unit to start (0~24 hours).
DELAYED POWER-OFF FUNCTION: While the appliance is running
with the desired settings, press the TIMER button, then use the UP and
DOWN buttons to set in how many hours time you require the unit to
stop (0~24 hours).
INTELLIGENT DEFROST
The appliance will defrost automatically when the coil sensor detects
that the internal temperature is too low. During defrosting the indicator
will light up. Once the defrost cycle has finished, the appliance will
return to the mode that was previously operating.
TANK-FULL
When the water tank is full, the TANK FULL indicator light will flash, and
the unit will stop operating. One emptied and replaced, the appliance
will resume operation.
OPTIONAL CARBON FILTER (Air purification function)
Remove the carbon filter from the bag and insert it on the filter housing.
It is suggested to hoover the carbon filter every 2-3 weeks and change it
every 3-6 months as this will help to ensure the room is kept fresh and
odour free.
8
Advertisement
Table of Contents
