Advertisement
Quick Links
Installation and Operating Instructions
(for chargers shown below)
IS1- One 6 amp output
IS2- Two 6 amp outputs
IS3- Three 6 amp outputs
For additional information please call our
Technical Support Group
615.471.5300
081512
PRO CHARGING SYSTEMS, LLC
1551 Heil Quaker Boulevard, LaVergne, TN 37086-3539
Advertisement
Related Manuals for Pro Charging Systems DUAL PRO Industrial Series
Summary of Contents for Pro Charging Systems DUAL PRO Industrial Series
- Page 1 (for chargers shown below) IS1- One 6 amp output IS2- Two 6 amp outputs IS3- Three 6 amp outputs For additional information please call our Technical Support Group 615.471.5300 081512 PRO CHARGING SYSTEMS, LLC 1551 Heil Quaker Boulevard, LaVergne, TN 37086-3539...
-
Page 2: Table Of Contents
615.471.5300 INTRODUCTION Pro Charging Systems (PCS) has been manufacturing waterproof, on-board battery charging systems since 1989. Our charging systems are designed and built tough to withstand intense vibration, extreme temperature variations and submersion without damaging the unit. Our systems use temperature compensation in order to fully charge a battery in hot or cold environments and are controlled by microprocessors in order to assure precise control over each totally independent charging bank. - Page 3 When using an extension cord, make sure: 1. That pins on the extension cord plug are the same number, size and shape as those of the charger’s plug; 2. That extension cord meets UL (Underwriters Laboratories, Inc.) acceptance and is in proper operating condition;...
-
Page 4: Product Summary
Use charger for charging a LEAD-ACID (lead acid, sealed lead acid, gel cell, and AGM) battery only. It is not intended to supply power to a low voltage electrical system other than in a starter-motor application. Do not use battery charger for charging dry-cell batteries that are commonly used with home appliances. These dry cell batteries may explode, causing personal injury and damage to property. -
Page 5: Installation Instructions
Light Emitting Diode (LED) indicator and one green Light Emitting Diode (LED) indicator. The Red (CHARGING) LED indicates d/c current is flowing to the battery and the Green (READY) LED indicates that the charger has finished it's bulk and absorption stage and has entered the float maintenance mode. There is also a Green (POWER) LED that illuminates to indicate that power is supplied to the charger when it is plugged in properly to a functioning A/C outlet. - Page 6 IMPORTANT NOTICE The mounting brackets of the system may contain keyholes that are designed so that screws can be started before putting the charger into place. If applicable, the keyhole locations vary depending on which model you own. Before making any connections, prepare batteries as follows: (a) With caps securely in place, thoroughly clean the case and posts with a solution of baking soda and water.
-
Page 7: Trouble Shooting
The charger pictured is a Professional Series Dual Pro, which has two independent 15 amp outputs. Connect a heavy duty UL approved extension cord to the power cord of your charger and then plug the extension cord into a nearby 120VAC GFI protected (Ground Fault Circuit Interrupt) outlet. You should now observe a red LED indication on each bank of the charger representing each individual battery being charged. -
Page 8: Warranty Information
LIMITED WARRANTY Pro Charging Systems, LLC (PCS) makes this Limited Warranty only to the original retail purchaser. PCS warrants this battery charger for 18 months from the date of retail purchase against defective materials and/or workmanship. If such defects should occur, this unit will either be repaired or replaced at the discretion of the manufacturer. - Page 9 Below are some of our other options in chargers and battery accessories. Call our technical support group for more detailed information or visit our web site www.dualpro.com.