Related Manuals for Pro Charging Systems Dual Pro SE XTREME
Summary of Contents for Pro Charging Systems Dual Pro SE XTREME
- Page 1 For additional information please call our Technical Support Group 800.742.270 072508 PRO CHARGING SYSTEMS, LLC 1551 Heil Quaker Boulevard, LaVergne, TN 37086-3539...
- Page 2 FOR THE FOLLOWING XTREME BATTERY CHARGERS: IMPORTANT NOTICE Please save and read all safety, operating and installation instructions before installing or applying AC power to your Pro Charging Systems (PCS) on-board battery charging system. Please contact PCS with any product, installation or service questions at 800.742.2740.
-
Page 3: Personal Precautions
Do not operate charger with a damaged cord or plug. Replace the cord or plug immediately. Do not operate charger if it has received a sharp blow, or if it has been dropped or otherwise damaged in any way; contact our technical support group for assistance (800.742.2740). Do not disassemble charger;... -
Page 4: Product Summary
PREPARING TO CHARGE If it is necessary to remove the battery or batteries to charge, always remove grounded terminal from battery first. Make sure all accessories are off, so as not to cause battery arcing. Be sure the area around any battery is well ventilated while batteries are being charged. “Gas fumes”... -
Page 5: Installation Instructions
The five red LEDs enable you to track the progress of the charge cycle on each battery as the voltage rises. Indications are as follows: “Charging on the run” Indications During periods in which the engine starting battery is being charged and maintained by the engine driven charging system, amber and red LED indicators are provided that display the state of the integrated ProXtra circuitry, which controls the flow of the current to additional batteries. -
Page 6: Trouble Shooting
Before making any connections, prepare batteries as follows: (a) With caps securely in place, thoroughly clean the case and posts with a solution of baking soda and water. Be careful not to allow any baking soda to get inside the case. (b) All battery posts, terminals and connectors should be cleaned to a shiny bright finish, using a wire brush or sand paper. -
Page 7: Trouble Shooting
Solution Sequence: With the AC power supply cord unplugged, check the ring terminals for correct polarity (Red to positive or + and Black to negative or -). Also check for corrosion free secure connections to the batteries. Call technical support for further assistance (800.742.2740). PROBLEM: The LED indications change rapidly back and forth from red to green, or the green LED will not illuminate after excessive charging time (16 hours or more). -
Page 8: Warranty Information
Please call PCS at 1.800.742.2740 for full warranty information and/or service. LIMITED WARRANTY Pro Charging Systems, LLC (PCS) makes this Limited Warranty only to the original retail purchaser. PCS warrants this battery charger for three years from the date of retail purchase against defective materials and/or workmanship.