Table of Contents
Advertisement
Table 2.12 for LEDs state of CPU temperature class.
2.5 Installation
2.5.1 HDD/SSD Installation
Step 1: Unscrew 4 screws on the underside, remove the bottom bracket;
Step 2: Unscrew 6 screws on the bottom cover;
Step 3: Unscrew 2 screws on the front/rear panel, remove the bottom cover;
Step 4: Put the HDD/SSD in the drive bay and screw 4 screws;
Step 5: Pull the drive bay onto the bottom cover and screw 4 screws, the hard drive direction is as shown;
Step 6: Using the SATA cable connect the HDD/SSD with the mother board;
Step 7: Close the bottom cover back to the chassis. screw 2 screws on the front/rear panel;
Step 8: Install the bottom cover, screw 6 screws;
Step 9: Install the bottom bracket, screw 4 screws.
Table 2.12: LEDs state of CPU temperature class.
LED
State
Red
Warning
Yellow
High
Green
Normal
20
User's Manual
Advertisement
Table of Contents
