Related Manuals for Jackson MSC CJ-16
Summary of Contents for Jackson MSC CJ-16
- Page 1 CJ-16 HOT WATER SANITIZING UNDERCOUNTER DISHMACHINE INSTALLATION OPERATION INSTALLATION OPERATION MANUAL MANUAL Visit Jackson on the Internet at: www.jacksonmsc.com November 2, 2000 P/N 7610-002-16-66...
- Page 2 DATE OF SHIPMENT FROM THE FACTORY. Jackson MSC agrees under this warranty to repair or replace, at its discretion, any original part which fails under normal use due to faulty material or workmanship during the warranty period, providing the equipment has been unaltered, and has been properly installed, main- tained and operated in accordance with the applicable factory instruction manual furnished with the machine and the failure is reported to the authorized service agency within the warranty period.
- Page 3 TABLE OF CONTENTS SECTION DESCRIPTION PAGE Specifications of the CJ-16 Detail of the CJ-16 Data Plate III. General Notes Section Installation Instructions Chemical Dispensing Equipment Chemical Timer Adjustments VII. Installation Checklist VIII. Operation Instructions Dimensions Jackson Maintenance & Repair Centers Electrical Schematics XII.
- Page 4 SPECIFICATIONS of CJ-16 ELECTRICAL REQUIREMENTS PERFORMANCE/CAPABILITIES WASH PUMP MOTOR HORSEPOWER OPERATING CAPACITY (RACKS/HOUR) RACKS PER HOUR VOLTS PHASE AMPS DISHES PER HOUR 23.2 GLASSES PER HOUR 20.4 OPERATING CYCLE (SECONDS) WATER REQUIREMENTS WASH TIME INLET TEMPERATURE 140°F RINSE TIME GALLONS PER RACK...
- Page 5 DETAIL OF THE CJ-16 DATA PLATE MANUFACTURER’S LOGO SERIAL NO.: MODEL DESIGNATION MODEL: 1 PH 60Hz 2 WIRE (I.E. “CJ-16”) ELECTRICAL RATINGS 208 VOLTS 230 VOLTS AMPERAGE LOAD WASH MOTOR 1 HP 1.5 A 1.5 A INFORMATION DRAIN PUMP MOTOR 1/20HP 0.1 A...
- Page 6 NOTE 3: The NSF logo on the data plate indicates that this machine has been approved to be listed under NSF Standard 3 by NSF International Inc. All of Jackson MSC’s Standard 3 approved dishmachines are listed on the NSF website at www.nsf.org. For more information concerning NSF International, their testing procedures and their standards in general, you may write to: NSF International Inc., 789 Dixboro Road, Ann Arbor, MI., 48105.
-
Page 7: Installation Instructions
It is also recommended that a shock absorber (not supplied with chased the unit. the CJ-16 model) be installed in the incoming water line. This pre- vents line hammer (hydraulic shock), induced by the solenoid UNPACKING THE DISHMACHINE: Once the machine has been valve as it operates, from causing damage to the equipment. -
Page 8: Chemical Dispensing Equipment
TO PREPARE PUMPS FOR OPERATION The CJ-16 dishmachine is supplied with detergent and rinse additive peristaltic pumps. Locate the open ends of the chemical tubes, insert the end of each tube onto the hub on the brass weight, and place each one in the appropriate container. -
Page 9: Chemical Timer Adjustments
CHEMICAL TIMER ADJUSTMENTS In general, it should not be necessary to alter the machine settings. The factory settings have been established to give the best results. IMPORTANT: To avoid wasting chemicals, remove tubes from soap and rinse-agent bottles before using the Service Mode. The sys- tem will always give an initial dose during the first cycle after switch-on, even though the wash tank may still be full. -
Page 10: Installation Checklist
INSTALLATION CHECKLIST CHECK OFF THE FOLLOWING ITEMS AS THEY ARE COMPLETED BEFORE PROCEEDING TO OPERATION OF DISHMA- CHINE. Has the dishmachine been checked for concealed/hidden damage? Has the dishmachine and the surrounding area been properly vented in accordance with all applicable codes? Has the dishmachine been properly leveled? Has the drain plumbing been installed with an air gap? Has the drain line been primed? - Page 11 OPERATION INSTRUCTIONS PREPARATION: Before proceeding with the start-up of the unit, OPERATIONAL INSPECTION: Based upon usage, the wash verify the following: strainers may become clogged with soil and debris as the work- day progresses. Operators should regularly inspect the wash 1.
- Page 12 Flush the arms out with fresh water. IMPORTANT: Remove only one nozzle at a time to ensure CJ-16 that you replace all of the nozzles as required. Each of the Wash Wash/Rinse Arm Nozzles are embossed with either an S or a D.
- Page 13 DIMENSIONS...
- Page 14 JACKSON MAINTENANCE & REPAIR CENTERS (USA) ALABAMA CALIFORNIA (cont) CONNECTICUT Jones-McLeod Appliance P & D Appliance GCS Service, Inc. #06 1616 7th Avenue North 100 South Linden Avenue 302 Murphy Road Birmingham, AL 35203 S. San Francisco, CA 94080 Hartford, CT 06114 (205) 251-0159 (650) 635-1900 (860) 549-5575...
- Page 15 JACKSON MAINTENANCE & REPAIR CENTERS (USA) FLORIDA (cont) ILLINOIS KENTUCKY GCS Service, Inc. # 13 GCS Service Inc. #12 Certified Service Center 4305 Vineland Road 696 Larch Avenue Ramco Business Park Suite G-12 Elmhurst, IL 60126 4283 Produce Road Orlando, FL 32811 (630) 941-7800 Louisville, Ky 40218 (407) 841-2551...
- Page 16 JACKSON MAINTENANCE & REPAIR CENTERS (USA) MARYLAND MICHIGAN MISSOURI (cont) GCS Service, Inc. #07 GCS Service, Inc. #20 Kammerlin Parts & Service 2660 Pittman Drive 31829 West Eight Mile Road 2728 Locust Street Silver Spring, MD 20910 Livonia, MI 48152 St.
- Page 17 JACKSON MAINTENANCE & REPAIR CENTERS (USA) NEW JERSEY NEW YORK (cont) OHIO (cont) Jackson Faspray Service Appliance Installation & Commercial Parts & 155 Sargeant Avenue Service Corp. Service of Columbus Clifton, NJ 07013 1336 Main Street 1150 West Mound Street (973) 471-8000 Buffalo, NY 14209 Columbus, OH 43223...
- Page 18 JACKSON MAINTENANCE & REPAIR CENTERS (USA) PENNSYLVANIA (cont) SOUTH CAROLINA (cont) TEXAS (cont) Food Service Equipment Whaley Foodservice Repairs Stove Parts Supply Co. 2101 Parkway South 748 Congaree Road 2120 Solana Street Broomall, PA 19008 Greenville, SC 29607 Ft. Worth, TX 76117 (610) 356-6900 (864) 234-7011 (817) 831-0381...
- Page 19 JACKSON MAINTENANCE & REPAIR CENTERS (USA) VIRGINIA WISCONSIN (cont) GCS Service, Inc. #18 Appliance Service Center, Inc. 5760 Northampton Blvd. 786 Morris Ave. Suite 106 Green Bay, WI 54304 Virginia Beach, VA 23455 (920) 496-9993 (757) 464-3500 (800) 236-0871 (800) 476-4278 (920) 496-9927 fax (757) 464-4106 fax WYOMING...
- Page 20 JACKSON MAINTENANCE & REPAIR CENTERS (CANADA) Kontac Industries 6504 South Broadway Edmonton, AB T6B0E7 (780) 469-4869 (800) 661-2500 (780) 465-6937 fax Key Food Equipment Services #105-3728 North Fraser Way Burnaby, BC V5J5G1 (604) 433-4484 (800) 665-2655 (604) 433-4684 fax Choquette - CKS 2710 Lancaster Road Unit 119 Ottawa, OT K1B4T7...
- Page 21 CJ-16 ELECTRICAL DIAGRAM 208-240 VOLT, 60 HERTZ, 1 PHASE...
- Page 22 CJ-16 ELECTRICAL DIAGRAM 12 VOLT CIRCUIT...
-
Page 23: Components Diagram
CJ-16 COMPONENTS DIAGRAM...