Hot water sanitizing upright door dishmachines (42 pages)
Summary of Contents for Jackson MSC DELTA 5
Page 1
DELTA 5 CHEMICAL SANITIZING DISHMACHINE INSTALLATION & & O O PERATION MANUAL Jackson MSC Inc. Visit Jackson on the Internet at: P.O. Box 1060 www.jacksonmsc.com Barbourville, KY. 40906 (606) 523-9795 July 31, 2001 P/N 7610-002-50-38 (Revision A)
Page 2
TRAVEL LIMITATIONS Jackson MSC limits warranty travel time to (2) two hours and mileage to (100) one hundred miles. Jackson MSC will not pay for travel time and mileage that exceeds this, or any fees such as those for air or boat travel without prior authorization.
TABLE OF CONTENTS SECTION TITLE/DESCRIPTION PAGE Specifications of the Delta 5 Installation Instructions III. Operation Instructions Dimensions Jackson Maintenance and Repair Centers 8 - Pin Harness Diagram VII. Electrical Diagram (115V, 60 Hz, 1 Phase) VII. Important Information Data Sheet...
SPECIFICATIONS OF THE DELTA 5 OPERATING CAPACITY (AS RATED BY NSF INTERNATIONAL): RACKS PER HOUR DISHES PER HOUR 1000 GLASSES PER HOUR 1000 OPERATING CYCLES (SECONDS) NORMAL CYCLE: WASH TIME RINSE TIME TOTAL CYCLE TIME HEAVY CYCLE: PREWASH TIME WASH TIME...
In areas where the water pressure fluctuates or is greater than the recommended pressure, it is suggested that a water pressure reg- ulator be installed. The Delta 5 does not come with a water pres- sure regulator as standard equipment.
OPERATION INSTRUCTIONS OPERATIONAL START-UP AND CHECK: Before proceeding being submerged in water. To enable the heater element: with the start-up, verify the following: Note: After completing step 2.v., you will still be in the pro- 1. Open the door and verify that the sump stariner is correctly gramming mode.
Page 7
OPERATION INSTRUCTIONS (CONTINUED) time is longer than the fill time, the incoming water solenoid valve 6. Adjust Dishmachine Flush Time will be opened for one second at the completion of the detergent dispensing, in order to flush out any remaining detergent from the a) The FLUSH will use fresh water to rinse out the deter- air gap.
Page 8
The machine must be idle (between cycles) for these prime buttons to be active. DELIMING OPERATIONS: The Delta 5 machine has a pre-pro- grammed delime sequence which will lead the operator through the steps required to properly delime the machine.
JACKSON MAINTENANCE & REPAIR CENTERS ALABAMA CALIFORNIA METRO APPLIANCE SERVICE GCS SERVICE INC #13 1640 S BROADWAY 4305 VINELAND RD STE G-12 DENVER, CO 80210 ORLANDO, FL 32811 JONES-McLEOD BARKERS FOOD MACHINERY (303) 778-1126 (407) 841-2551 APPLIANCE SVC EQUIPMENT 800-525-3532 800-338-7322 1616 7TH AVE.
Page 11
JACKSON MAINTENANCE & REPAIR CENTERS IDAHO CONES REPAIR SVC. MAINE GCS SERVICE INC. #09 1056 27TH AVENUE SW 180 SECOND STREET CEDAR RAPIDS, IA 52404 CHELSEA, MA 02150 RESTAURANT APPLIANCE SVC. GCS SERVICE INC. #09 (319) 365-3325 (617) 889-9393 7219 ROOSEVELT WAY NE 180 SECOND STREET 800-747-3326 800-225-1155...
Page 12
JACKSON MAINTENANCE & REPAIR CENTERS MISSOURI NEW HAMPSHIRE NEW YORK WHALEY FOODSERVICE REPAIRS 335-105 SHERWEE DRIVE GCS SERVICE INC. #82 GCS SERVICE INC. #09 APPLIANCE INSTALLATION RALEIGH, NC 27603 6107 CONNECTICUT 180 SECOND STREET AND SERVICE CORP. (919) 779-2266 KANSAS CITY, MO 64120 CHELSEA, MA 02150 1336 MAIN STREET FAX: (919) 779-2224...
Page 13
JACKSON MAINTENANCE & REPAIR CENTERS KRUEGER INC. GCS SERVICE INC. #48 SOUTH DAKOTA GCS SERVICE INC. #88 100 NE 24TH STREET 210 VISTA PARK DRIVE 8150 WESTPARK OKLAHOMA CITY, OK 73105 PITTSBURGH, PA 15205 HOUSTON, TX 77063 GCS SERVICE INC. (405) 528-8883 (412) 787-1970 (713)785-9187...
Page 14
JACKSON MAINTENANCE & REPAIR CENTERS GCS SERVICE INC. #07 APPLIANCE SERVICE INTERNATIONAL 2660 PITTMAN DRIVE CENTER, INC. SILVER SPRING, MD 20910 6843 W. BELOIT RD. GLOBAL PARTS AND SUPPLY (301) 585-7550(DC) WEST ALLIS, WI 53219 7758 NW 72ND ST (410) 792-0388(BALT) (414) 543-6460 MIAMI, FL 33166 800-638-7278...
Need help?
Do you have a question about the DELTA 5 and is the answer not in the manual?
Questions and answers