LoadLifter 5000 Ultimate
SECURING THE AIR SPRING TO THE BRACKETS
1 . Align the bellows (A) in and out so that they are perpendicular to the upper and lower
NOTE
Keep a finger's width between the roll plate (D) and frame (Figure 6).
2 . Tighten both upper and lower bellows mounting bolts . Torque to a maximum of 20 ft .lbs .
RELOCATING THE JOUNCE BUMPER
1 . The jounce bumper must be relocated under the frame above the axle . First, remove
2. Drill a 3/8" hole above the axle, in the bottom of the frame flange (Figure 7).
MN-857
brackets (Figure 5) .
the jounce bumper from the stock bracket .
fig. 6
fig. 7
7