Heater - Artic FUSION SPLICER 4.3 User Manual

4.4.4. Arc numbers
This option shows the total number of Arc discharges.
4.4.5. Fiber Position
Press the key to enter the video interface. Press the key to switch the left and right motors. The
align motor will move up or down by pressing the key or . The push motor will drive left or right
by pressing the key or
4.5. Heater
The Heater menu is used to set heating time and heating mode, as shown in Figure 4.18. Heater
mode includes two kinds, automatic mode and manual mode. In automatic mode, after the heater
the heat shrink tubing loaded and the cover closed, the program begins heating automatically. In
manual mode, users need to press the key "HEAT" to begin heating after the heater cover closed.
Heat time needs to set by users according to specific heat shrinkable. Select this option "Heat Time",
and press the key or to change the time. Select the option "Auto Heat", and press the key or
to change the mode.
FIGURE 4.18
24
USER MANUAL HANDHELD FTTX FUSION SPLICER FUSION SPLICER 4.3