Axis AX-513 Manual page 4

MVP Group Corporation (Axis) hereby warrants all new ovens bearing the name "AXIS" and installed within the continental
United States of America or Canada to be free from defects in material or workmanship, under normal and regular usage and
operation, for a period of one (1) year following the date of original installation, (unless specified otherwise) but in no event can
exceed eighteen (18) months from the date of shipment from the factory.
If a defect in material(s) or workmanship is detected; or found to exist within the stated period above, Axis, at its sole discretion,
shall either repair or replace any original equipment manufacturers part which has proven to fail within the machine; providing
that the equipment has not been altered or tampered with in any manner, has been installed correctly as per the owner's
manual, and maintained and operated in complete accordance with this manual.
The labor cost to repair or replace any part proven to be defective, as per above clause(s), shall be covered by Axis, within the
continental United States of America or Canada; provided that: prior authorization for this labor was approved by Axis, the
service work was performed by an authorized Axis service agency; and that this agency installed an original and genuine Axis
part in the machine. Any repair work performed by a non-authorized service depot remains the sole responsibility of the user,
and Axis Systems will not be held responsible. The installation of any generic part will not be valid; and therefore voids this
warranty. All authorized labor coverage shall be limited to regular hourly rates only. Any supplemental hourly rates or charges,
such as weekends or emergency premiums remain the responsibility of the user.
MVP Group Corp. (Axis) hereby states that: warranty travel time shall be limited to, and without exception, a one-time round-trip
total of two (2) hours OR mileage up to a maximum of one hundred (100) miles round-trip. Any charges exceeding those stated
herein must have prior authorization by the factory.
Exceptions to above warranty are: (A) Damages resulting from shipping, handling or abuse. (B) Incorrect installation and/or
connections. (C) Adjustments or calibration of any parts. (D) Faults due to lack of regular maintenance or cleaning of any internal
part(s). (E) Replacement of any wearable items such as: gaskets. (F) Excessive lime, mineral, alkali or hard water conditions and
(G) Excessive or inadequate water temperature(s) or pressure conditions.
MVP GROUP CORPORATION STATES THAT THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, THAT ARE NOT SET
FORTH HEREIN, MVP GROUP CORPORATION SHALL ASSUME NO OTHER RESPONSIBILITY, EITHER DIRECT OR NON-DIRECT, OR BE
LIABLE FOR ANY OTHER OR ADDITIONAL LOSS OR DAMAGE WHETHER BEING DIRECT OR CONSEQUENTIAL, AS A RESULT OF ITS
EQUIPMENT.
MANUFACTURERS LIMITED WARRANTY
4