Axis AX-513 Manual page 17

The cooking cycle will start again by pressing START/STOP from where it left off.
END flashes on the display at the end of a cooking cycle, fan, humidifying and heating stop and it beeps for 40
seconds. If a time is programmed during these 40 seconds using the INCREASE / DECREASE buttons and is
confirmed by pressing the TIME button, the oven will automatically start cooking again with the previous temperature
parameters.
Otherwise START/STOP stops the beep and the oven stops completely.
The oven turns off automatically after 15 minutes of each cooking. To turn it ON again , press ON/OFF.
PROGRAMMED COOKING
The oven has a possibility of 99 pre-programmed recipes, each
one with 3 cooking phases.
To put the oven on MANUAL press PROGRAMS / MANUAL
once. This enables PROGRAMS and the PROGRAMS LIBRARY
light and PHASES comes on.
Recipe P01 can be seen on the CHAMBER/PROGRAMS display.
Select the cooking program with INCREASE / DECREASE and
the saved values will appear on the display after 5 seconds.
Now the time, temperature and humidifying can be set in the
various phases as previously described. The PHASES icon
always shows the current program phase.
By pressing PROGRAMS/MANUAL once at any time the program
can be viewed.
By pressing START/STOP once the cooking program starts.
END flashes on the display at the end of a cooking cycle, fan,
humidifying and heating stop and it beeps for 40 seconds. If a
time is programmed during these 40 seconds. After the 40
seconds the beeping stops and the oven is ready to repeat the
same previously selected program.
Otherwise START/STOP stops the beep and the oven goes back
to MANUAL COOKING.
PROGRAM MEMORIZATION: keep
pressed for per 4 seconds. Memorization is confirmed by a beep
for a few seconds and the program number with MEM will appear on the display.
RETURN TO MANUAL COOKING: to go back to
programs:
Press PROGRAMS/MANUAL once and the previously selected cooking program number will flash for 5 seconds. By
pressing PROGRAMS/MANUAL once during these 5 seconds, MANU (manual) will appear on the display. Wait 5
seconds to confirm selection.
In manual cooking the icons PROGRAM LIBRARY and PHASES will turn off.
SET PARAMETERS
PRE-HEATING
Pre-heating allows the oven to come up to the desired temperature before it is ready to cook. To change the setting for
the pre-heating option do the following:
keep INCREASE – DECREASE pressed at the same time for 4 seconds, then press INCREASE until "language"
comes up on the display. Press INCREASE to change the desired menu until you reach "Pre-Scaldo", press
HUMIDIFYING to access the menu, press INCREASE– DECREASE to select the ON or OFF, confirm selection by
pressing START/STOP.
To exit the menu press ON/OFF.
PROGRAMS/MANUAL
MANUAL you have to follow the procedure below to exit
17
COOKING PROGRAMS
P# PHASE TIME
PD1
1
00:05
2
00:25
3
00:10
PD2
1
2
3
PD3
1
2
3
PD4
1
2
3
TEMP HUM %
375F 0%
350F 20%
300F 5%