Table of Contents
Advertisement
Screw back on glass cover "A" while observing washer "C".
—
Put the side grids back on ensuring they are well fitted.
—
Should the glass lid be broken or damaged, do not use the oven until the lid is replaced (Contact the
—
customer support Centre
REPLACEMENT AND CLEANING OF COOLING FILTER
WARNING: Strictly adhere to the following procedure in order to avoid electrocution or damage to
people:
Disconnect the electrical connection of the oven and leave it to cool.
—
—
Loosen the grid screws and substitute or clean the filter.
Once this is done put everything back together.
—
SPECIAL MAINTENANCE
It is advisable to have the appliance subjected to periodical checks (at least once per year) by a
specialised authorized technician.
Any maintenance, installation or repair work must be carried out by qualified authorized personnel by
contacting the Customer Support Centre. Before carrying out any operation the appliance must be
unplugged at the mains, close the water valve and wait for it to cool down. Before moving the
appliance from position, check that the electricity and water connections (electric cables, water pipe
and drainage) are correctly disconnected.
If the appliance is on wheels check that electric cables, pipes or anything else are not damaged while
moving it. Ensure the wheel-break is on. Avoid placing the device near heat (such as fryers etc.). After
carrying out the task and replacing the appliance in it's initial position, check that the electric and
water are connected correctly.
MAINTENANCE IN CASE OF BREAK-DOWN
If the appliance breaks, disconnect it from the mains and turn off water.
Before calling Customer Service, check the chart on page 22.
POWER FAILURE
In case of power failure during the cooking cycle, the oven turns automatically into the OFF position.
SIGNALS AND ALARMS
Alarms appear on the display while everything else is off and a beep warns of an anomaly.
The beep can be stopped by pressing START/STOP.
ER1
Chamber Probe Alarm.
It occurs in case of failure of the chamber probe.
The oven is deactivated completely except for the light and the cycle in progress is interrupted.
ER2
Oven Safety Thermostat Alarm.
It occurs in case of malfunctioning regarding the heating of the oven.
The entirety is deactivated and the cycle in progress is interrupted.
).
19
Advertisement
Table of Contents
