Power Off Your Projector - InFocus LightPro IN1004 User Manual

Basic operation

Power off your projector

1. Press the Power button at the top control
panel or the remote control, the "Power off?"
message displays.
2. Press the Power button again in 4 seconds
after the "Power off?" message prompted
to you. The POWER indicator flashes red
while the cooling fan continues running. (You
may set up noise level and speed of the fan.)
Unplug the power cord until the fan stops
running. Failure to do so may shorten life
cycle of your projector or lead to power on
failures or operation abnormalities.
3. The POWER indicator stops flashing once
the projector has been cooled down to ready
for power on again.
To maintain the life cycle of the lamp, only power off your projector after it has
been turn on for at least five minutes.
Do not leave your projector turned on for extended periods of time. As it may
hurt the life cycle of your lamp. Power off your projector at least once every
24 hours and have it idle for an hour.
Note
• If the "Direct power on" function is set to "On", your projector will power on once
it is connected to an AC power socket.
• Speed of the cooling fan speed varies based on the internal temperature of your
projector.
• Do not place your projector in any box before it is fully cooled down.
• In case the POWER indicator flashes or turns red, refer to the "WARNING light
indicator" for instructions.
• The POWER indicator flashes when the lamp is cooling down. Do not power on
your projector at this time. Power on your projector only after the POWER indicator
turns red.
• Unplug the power cord after your projector has been turned off. The fan stops
running.
• The POWER indicator turns red when your projector is ready for power on again.
It takes less time to restart your projector after it was powered off in the standard
power off procedure than that of the non-standard one.
Power off?
"Power off?" message
disappears in 4 seconds.
www.infocus.com 34