Table of Contents
Advertisement
Synology SA3600 at a Glance
No.
Article Name
1
Power Button and Indicator
2
Status Indicator
3
Alert Indicator
4
Beep Off Button
5
Drive Status Indicator
6
Drive Tray
7
Rail Kit Release Tab
8
Power Port
PSU Indicator and Beep Off
9
Button
10
PSU Fan
11
Console Port
12
PCI Express Expansion Slot
13
SAS OUT Port
14
1GbE LAN Port
15
10GBase-T LAN Port
16
USB 3.0 Port
17
Reset Button
1
For more information about the rail kit installation, please refer to the Quick Installation Guide that comes with the rail kit.
2
For more information about Synology Expansion Unit supported by your Synology NAS, please visit www.synology.com.
4 Chapter 1: Before You Start
Location
1. Press to power on your Synology NAS.
2. To power off the Synology NAS, press and hold until you hear a beep
sound and the Power LED starts blinking.
Displays the status of the system. For more information, see "LED Indicator
Table."
Displays warnings regarding fan or temperature. For more information, see
"LED Indicator Table."
Front
Press to deactivate the beeping sound that is emitted when a malfunction
occurs.
Displays the status of drives. For more information, see "LED Indicator Table."
Install drives (hard disk drives or solid state drives) here.
Push in and hold to release the Synology NAS from the rail kit lock.
Connect power cords here.
1. Displays the status of the power supply unit (PSU). For more information,
see "LED Indicator Table."
2. Press to deactivate the beeping sound that is emitted when a malfunction
occurs.
Disposes of excess heat and cools the PSU.
This port is used for manufacturing use only.
Supports additional PCIe network interface cards.
Connect to Synology Expansion Unit
Back
Connect RJ-45 network cables here.
Connect RJ-45 network cables here.
Connect external drives, USB printers, or other USB devices to the Synology
NAS here.
1. Press and hold until you hear a beep sound to restore the default IP
address, DNS server, and password for the admin account.
2. Press and hold until you hear a beep sound, then press and hold again until
you hear three beep sounds to return the Synology NAS to "Not Installed"
status so that DiskStation Manager (DSM) can be reinstalled.
Description
2
here.
1
Advertisement
Table of Contents
