SAFETY INSTRUCTIONS Please read the instruction carefully. Remove all parts and hardware from the carton and place them on soft and clean surface. Check that nothing is missing. Please recycle all packaging materials. • Follow the instructions carefully. Failure to follow these instructions may result in serious injury or damage.
PARTS LIST Specifications / Name Picture Qty. A1,A2,A3,A4 M12x180 mm B1,B2,B3,B4,B5 M12x180 mm C1,C2,C3,C4 M12x180 mm D1,D2,D3 M10x100 mm E1,E2,E3 M10x90 mm F1,F2,F3 M8x120 mm G1,G2,G3 M8x90 mm H1,H2,H3 M8x45 mm I1,I2,I3 M8x45 mm J1,J2,J3 M8x20 mm K1,K2 M8x16 mm Small spring Wheels...
Page 5
Top pole cover Mesh Bracket Big spring Board rod holder (short) Board rod holder (long) U1,U2 Pole support rods Axle Top pole Middle pole Bottom pole Base Board bracket...
Page 6
Board EE,FF M12x180 mm Inner height adjustment rod Outer height adjustment rod...
ASSEMBLY WARNING! Assembly can only be performed by an adult. 4 adults are recommended for installation. Step 1 Create a post with parts W, X, Y. Attach bracket Q to the post X with bolts, washers and nuts G1, G2, Step 2 Tighten the pole with a few strikes against a piece of wood.
Page 8
Step 3 Connect the posts W, X and Y with bolts, washers, and nuts E1, E2, E3. Attach the wheels M to the base BB with the axis V. Then attach the bottom post Y to the base BB. The bracket Q on the post X must face backwards.
Page 9
Step 5 Attach rim AA and board bracket CC to the board DD with bolts, washers, and nuts F1, F2, F3 and I1, I2, I3. Two small springs L are attach to the front of the rim AA with bolts, washers, and nuts F1, F2, F3.
Page 10
Step 6 Open the board bracket CC on both sides. Attach the board bracket to the board with bolts and washers K1, K2. Then secure the rods S, T to the bracket CC with bolts and washers B1, B2, B3, B4, B5. Bushing B3 must be inserted in to the bracket CC.
Page 11
Step 7 Rods S, T attach to the post W with bolts, washers, and nuts C1, C2, C3, C4. Step 8 Attach outer height adjustment rod HH to the rod T with bolts, washers, and nuts A1, A2, A3, A4 as shown.
Page 12
Step 10 Attach big springs R to the board holder CC and to the bolt EE. Step 11 On top pole W attach pole cover N. Attach mesh P on the rim AA.
Step 12 Fill the base with sand or water. MOVING • Lower the basket to the lowest position. • Grasp the post and tilt the base onto the wheels. • Move the basket on the wheels. • Place the basket in the desired location. •...
By proper disposal you will protect the environment and natural sources. Moreover, you can help protect human health. If you are not sure in correct disposing, ask local authorities to avoid law violation or sanctions. TERMS AND CONDITIONS OF WARRANTY, WARRANTY CLAIMS General Conditions of Warranty and Definition of Terms All Warranty Conditions stated here under determine Warranty Coverage and Warranty Claim Procedure.
Need help?
Do you have a question about the 22637 and is the answer not in the manual?
Questions and answers