HighSecLabs SC21H-3 Quick Setup Manual page 5

Table of Contents SECTIONS
INSTALLATION
Step 2 - Power ON the Combiner
1. Turn ON both PCs.
2. Connect the power supply and power ON the
Combiner. The Combiner boots up, as follows:
•
If you are using the Combiner for the first
time, the default display mode is picture-in-
picture (PiP).
•
Otherwise, the Combiner boots into the
display mode used during the previous
power on, including either:
− Full-screen - either channel #1 only
or channel #2 only
− Picture-in-picture (PiP)
− Side-by-side
− Custom mode
Note: In case no picture is presented after powering on the Combiner,
connect an alternate display to the combiner's display console port, or
perform a reset to factory default.
HSL Secure 2-Port KVM Combiner Quick Setup Guide
1 2 3
5