Table of Contents
Advertisement
Connect the water inlet hose to the
1.
appliance.
1
Connect the water inlet hose to the
2.
tap (26.4 mm = 3/4").
Open the tap carefully and check
3.
that the connections are tight.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
Remark: Take the information on the
topic of safety → Page 4
and avoid material damage
→ Page 11 take care of your device
to use safely.
LOOK OUT!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
The water drain hose against un-
▶
intended to secure loosening.
2
¾
min.
10mm
min.
17mm
Set up and connect NL
Remark: Observe the pumping
heights.
The maximum pumping height
wears 100 cm.
Drain in a
washbasin
Drain in and
plastic stand
pipe with rubber
run sleeve or in a → Page 35
drain.
4.6 Adjusting the device
To reduce noises and vibrations and
to prevent the device from walking,
adjust the device horizontally.
Remark: Take the information on the
topic of safety → Page 4
and avoid material damage
→ Page 11 take care of your device
to use safely.
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
→ Page 35
confirm and
secure.
the water drainage
feeding hose with
a bend
confirm and
secure.
17
Advertisement
Table of Contents
