Table of Contents
Advertisement
NL Troubleshooting
Malfunction
strong foam
ming.
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
fizzing, hissing
loud.
58
Cause and Troubleshooting
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
During the next wash, reduce by an equal amount.
▶
load the amount of detergent.
Low spin speed is set.
For the next wash, set a higher spin
▶
speed in.
is activated.
Select a suitable program for the type of fabric.
▶
→ "Programs", Page 27
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
Start the program Centrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and water drain
▶
feed hose is not kinked or pinched.
The unbalance detection system has aborted the spin
cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
Start the program Centrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
Advertisement
Table of Contents
