Table of Contents
Advertisement
washbasin
plastic stand
pipe with rubber
run muff or a
floor drain
4.7 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
fixate and
gene.
the water drainage
feeding hose with
a bend
fixate and
gene.
Set up and connectNL
To adjust the appliance, turn the
2.
appliance feet. Check the horizontal
adjustment of the appliance with a
spirit level.
All appliance feet must be firmly
planted on the floor.
Tighten the lock nuts against the
3.
housing with an open-end wrench
SW17 hand-tight.
Hold the appliance foot while
doing so and do not adjust the
height.
4.8 Connecting the appliance
electrically
Remark:Your home electrical
installation for this appliance must
comply with local legal and safety
regulations and must include an
earth leakage circuit breaker.
17
Advertisement
Table of Contents
