Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
56
Cause and Troubleshooting
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and water drain
▶
feed hose is not kinked or pinched.
Drain pump is clogged.
→ " Cleaning the drain pump", page 47
▶
is activated.
Resume the program by Centrifuge or off-
▶
pumps to choose and press .
Water drain hose is connected too high.
Mount the water drain hose at a maximum of 1 meter
▶
height.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
During the next wash, reduce by an equal amount.
▶
load the amount of detergent.
Unauthorized extension mounted on the water drain
hose.
Remove any unauthorized extensions from the
▶
water drain hose. Connect device
was not pressed.
Press .
▶
The
sieves in the water supply are clogged.
Clean the strainers in the water supply → Page 50.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Advertisement
Table of Contents
