Table of Contents
Advertisement
LOOK OUT!
If the appliance is installed in areas
with a risk of frost or outdoors, frozen
residual water can damage the
appliance and frozen hoses can
rupture or burst.
Do not operate the appliance in a frost-sensitive
▶
placed or placed outside and used.
The device was subjected to a function
test before leaving the factory and
may contain residual water. This
residual water can leak if the
appliance is tilted more than 40°.
Carefully tilt the device.
▶
installation site
On a pedestal
On a floor with The appliance on
wooden beams
In a kitchen
To demand
The device with
locking lips
→ Page 35
to confirm.
a water resistant
solid wooden plate
places, which
screwed to the
floor. The
wooden plate
must be at least
be 30mm thick.
s A niche width
of 60 cm is
necessary.
s The device
only under
a continuous
pend worksheet
place, which
stuck with the
adjacent
cabinet is connected
Pine tree.
Set up and connect NL
installation site
on a wall
4.4 Transportation
remove
The device is secured for transport
with transport locks at the rear of the
device.
Comments
s Take the information about the
subject security → Page 4 and
avoid material damage
→
Page 11 be aware of your appli-
to use safely.
s Keep the transport safeguards,
the bolts and sleeves for future
transport → Page 62.
Pull the hoses out of the holders.
1.
To demand
no snakes
between wall and
device clamping
man.
protections
15
Advertisement
Table of Contents
