Table of Contents
Advertisement
NL Troubleshooting
Malfunction
"E:36 / -25 / -26"
flashes.
burns.
flashes.
54
Cause and Troubleshooting
Drain pump is clogged.
→ " Cleaning the drain pump", page 47
▶
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
Clean the strainers in the water supply → Page 50.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The voltage monitoring system detects an
impermissible voltage drop.
No solution possible.
▶
Remark: When the supply voltage has stabilized, the
program continues normally.
Undervoltage can cause a program extension.
No solution possible.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
During the next wash, reduce by an equal amount.
▶
load the amount of detergent.
Temperature is too high.
Wait for the temperature to drop.
▶
→ " program cancel", page 43
▶
Water level is too high.
Start the program pump down.
▶
Laundry is wedged in the door.
Open the door again.
1.
Remove trapped laundry.
2.
Close the door.
3.
To start the program, press
4.
Door is not closed.
Close the door.
1.
To start the program, press
2.
.
.
Advertisement
Table of Contents
