Yard force YF4050PB Operator's Manual page 16

WARNING!
Before following action, make sure the ON/OFF switch is on the "OFF "position.
The following accessory is required for connecting to the pressure washer (not
supplied):
1. A water supply hose – it is a fabric-reinforced hose with a minimum diameter of
½ inch.
2. Screw the inlet adapter onto the pressure washer.
3. Attach a water supply hose with coupling connector(supplied) to the inlet adapter.
4. Connect the other end of water supply hose to the potable water tap.
Using the water container as water source
As shown in Fig.10-13
This high-pressure washer is equipped with water container that is convenient to use
in case of no sustainable water supply or far away from the water source .
1. Fill the container with clean water either by using other water carriers or
sustainable water source.
Fig. 10 Fig. 11 Fig. 12
14
YF4050PB.indd 14 15-5-4 11:42