Table of Contents
Advertisement
Maintenance and Troubleshooting
Lamp Replacement
1. Remove the lamp screw from the lamp door.
2. Remove the Lamp Door.
3. Remove the two Phillips head screws that hold the lamp in place.
4. Grasp the handle on the top of the lamp and pull the lamp straight up
out of the projector.
5. Slide the replacement lamp into place and press firmly to seat the lamp.
6. Reinstall the screws removed in step 3.
7. Reinstall the lamp door correctly and tighten the screw on the lamp
door.
8. Please see page 61 for resetting the lamp timer.
C A U T I O N
WARNING
72
Lamp door
The lamp and inside of the projector become very hot
while the projection lamp is lit. Allow the projector to
cool for at least 15 minutes prior to opening the lamp
door.
Do not touch the bulb. Touching the bulb will greatly
decrease the life of the lamp and could cause the bulb
to explode.
Lamp Screw
Advertisement
Table of Contents
