Table of Contents
Advertisement
Basic Operation
Turning off the Projector - Procedure
Press the power button on the projector or remote control. The
1.
power off confirmation message appears .
Press the power button again and the projector will enter cool-down
2.
mode. The lamp shuts off, the lamp indicator flashes red, and the
fans continue to run for approximately two minutes. During the cool
down sequence the projector will not respond to any control panel
or remote control buttons.
C A U T I O N
After the cool-down sequence is completed the fans will shut off
3.
and the lamp indicator will stop flashing. The projector is now in
standby mode and can be turned back on with the remote control
or control panel. If the projector will not be used for an extended
period, set the power switch to off and disconnect the power cord.
Do not set the power switch to off or unplug the
projector during the cool-down sequence. Not allowing
the lamp to cool properly will greatly reduce the life
of the lamp.
51
Advertisement
Table of Contents
