Power Management Setup - AMD 770 User Manual

The optional settings are: IrDA(1.6 ns) and IrDA (3/16 bit).
IrDA Duplex Mode/Serial Port 2 Mode
This item allows BIOS to select full or half duplex for serial port 2(IR Mode).The optional
settings are: Full Duplex; Half Duplex.
IrTX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select transmit pin in a normal condition or inverse the IRTX(IR
Mode).
IrRX Pin Select
The optional settings are: Normal and Inverse.
This item allows BIOS to select receiver pin in normal condition or inverse the IRRX(IR
mode).
IRTX to RX Delay Select
The optional settings are: No Delay and Reception Delay.
This item allows BIOS to select IR from RX to TX 4 characters time delay for serial port2(IR
mode)
IRRX to TX Delay Select
The optional settings are: No Delay and Transmission Delay.
3-8

Power Management Setup

The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
XBLUE- 77A3
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Feature
Power Management/APM
Suspend Time Out
Power Button Mode
Video Power Down Mode
Hard Disk Power Down Mode
Hard Disk Time Out (Minute)
RTC Resume
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Discard Changes F6:Standard Settings F7: Optimized Settings
XBLUE- 78GA3/XBLUE- 78VA3
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Feature
Power Management/APM
Suspend Time Out
Power Button Mode
Video Power Down Mode
Hard Disk Power Down Mode
Hard Disk Time Out (Minute)
Restore on AC Power Loss
RTC Resume
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Power Management Setup
Enabled
Disabled
On/Off
Suspend
Suspend
Disabled
Disabled
Power Management Setup
Enabled
Disabled
On/Off
Suspend
Suspend
Disabled
Disabled
Disabled
F6:Fail-Safe Defaults
35
Help Item
Disable/Enable
RTC to generate a wake event
Help Item
Disable/Enable
RTC to generate a wake event
F7:Optimized Defaults