Advanced Bios Features - AMD 790GX User Manual

Primary IDE Master / Slave
SATA Channel 1, 2, 3, 4, 5, 6
While entering setup, BIOS auto detest the presence of IDE devices. This displays
the status of auto detection of IDE devices.
Type: The optional settings are: Not Installed; Auto; CD/DVD and ARMD
LBA/Large Mode: The optional settings are Auto; Disabled.
Block (Multi-Sector Transfer): The optional settings are: Disabled and Auto.
PIO Mode: the optional settings are: Auto, 0, 1, 2, 3 and 4.
DMA MODE: the optional settings are Auto, SWDMAn, MWDMAn , UDMAn.
This option allows you to enable the HDD S.M.A.R.T Capability
S.M.A.R.T.:
(Self-Monitoring, Analysis and Reporting Technology). The optional settings are Auto;
Disabled; and ENABLED.
32 Bit Data Transfer: the optional settings are: Disabled and Enabled.
Floppy A
This item is for specific floppy disk drive settings. Select according to the specification
of the floppy disk you use.
System Memory
This item will show information about the memory modules(s) installed.
3-5 Advanced BIOS Feature
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Advanced Settings
WARNING: Setting wrong values in below sections
May cause system to malfunction
CPU Configuration
Boot Sector Virus Protection
Removable Drives
Quick Boot
ST
1 BOOT Device
Boot up Number Lock
ACPI APIC Support
MPS Revision
Quiet Boot
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Boot Sector Virus Protection
The selection Allow you to choose the VIRUS Warning
feature for IDE Hard Disk boot sector protection. If this function is enabled and
someone attempt to write data into this area, BIOS will show a warning message on
screen and alarm beep.
Disabled (default) No warning message to appear when anything attempts to
Enabled
Removable Drives
Use this item to specify the boot device priority sequence from available removable
drives.

Advanced BIOS Features

Press Enter
Disabled
Press Enter
Enabled
st
1 Floppy Drive
On
Enabled
Enabled
Disabled
F6:Optimized Defaults
access the boot sector or hard disk partition table.
Activates automatically when the system boots up causing a
warning message to appear when anything attempts to access
the boot sector of hard disk partition table.
Configure CPU
F7:Standard Defaults
25
Help Item