NORPOLE EWCIM350S1 User Manual page 18

Ice level light Ice maker is full of ice normally.
on.
Dash plate is blocked by ice and can not
reset.
Ice full on display when the ice
basket is with little ice.
Hall device, connector or components
are loose.
Hall device breakdown.
Breakdown of magnetic valve.
Fault light on. Not making ice.
Magnetic valve malfunction.
Breakdown of compressor.
Breakdown of pump.
Breakdown of sensor, Hall device
condensor sensor water level sensor.
Ice full, water Overheating of the cooling system when
shortage and the fan malfunctions.
breakdown
lights all on.
Makes ice Breakdown of the magnetic valve.
normally but
cannot drop it.
Low ambient temperature,
below 50°F/10°C.
The machine Scale or impurities in water circulation
functions system or spray pipe or pump.
normally but the
ice has obvious
holes.
Remove ice.
Automatically reset after the ice melts.
Open the door and take out the ice in
blockage.
Connect the wire on the control board to
the evaporator.
Change the Hall device.
Change the dash plate.
Change the ice dropping magne.
Change the compressor.
Change the pump.
Change the sensor.
Change the condensor fan.
Change the ice dropping magnetic valve.
Locate the unit per installation
instructions.
Clean the pipeline.
18