NORPOLE EWCIM350S1 User Manual page 14

c. Change the condensor sensor.
d. Change the water inlet valve.
NOTE: Sometimes the water inlet valve is blocked instead of broken and needs to be cleaned only.
e. Change the ice thickness controller.
NOTE: Sometimes it is poor contact caused by scale, and only cleaning is needed instead of
changing.
f. Change the Hall device.
Remove
the cover
and open
the door.
Remove
the
cover
and
open the
door.
Remove the cover, open the door, remove the dash
plate and control box cover, and remove the Hall device
connecting wire.
Use slot type screwdriver to remove the Hall device and
change for the new one.
14
Remove the grill and cover, open the
control box cover, and remove the
condensor connector.
Cut the tie holding the condenser
sensor to remove it and replace with
a new one.
Push the dash plate to
one side until the hook is loose
and remove the dash plate.
Remove the ice thickness
controller and connecting wire,
and change for a new one and
reconnect the wire.
Figure 8
Figure 9
Remove the water
inlet valve fi xing
screw, water pipe
fi xing clip and water
pipe and replace
with the new water
inlet valve.
Figure 10
Figure 11