OpenEye OE-C2012B4 Quick Start Manual

CONNECTIONS

1
2
3
4
Waterproof Cable
5 4
1 1 Thread lock cap Thread lock cap
2 2 Rubber plug Rubber plug
3 3 RJ45 enclosure RJ45 enclosure
Liberty Lake, WA, USA
509.232.5261
openeye.net
1 1 RJ-45 RJ-45 For network and PoE connections For network and PoE connections
2 2 Power (12vDC)* Power (12vDC)* Power connection Power connection
Ground Ground
3 3 Audio I/O Audio I/O Audio In Audio In
Audio Out Audio Out
Ground Ground
Alarm In Alarm In
4 4 Alarm I/O Alarm I/O
Alarm Out - Alarm Out -
Alarm Out + Alarm Out +
*12vDC power input port should be plugged when not in use.
1
2
To restore the camera to factory To restore the camera to factory
defaults: defaults:
1. Disconnect power for 30 1. Disconnect power for 30
seconds. seconds.
1 1 Reset Jumper Reset Jumper
2. Reconnect power and wait 30 2. Reconnect power and wait 30
seconds. seconds.
3. Close the jumper connection 3. Close the jumper connection
with a proper tool for 20 seconds. with a proper tool for 20 seconds.
Supports up to 512GB microSD Supports up to 512GB microSD
card for Edge storage. card for Edge storage.
2 2 microSD Card Slot microSD Card Slot Do not add or remove the Do not add or remove the
microSD card when the camera microSD card when the camera
is powered on. is powered on.
3 1
2
4 4 Rubber "O" ring Rubber "O" ring
5 5 Camera cable Camera cable
Copyright ©2021 OpenEye.
All Rights Reserved. Information contained in this
document is subject to change without prior notice.
OpenEye does its best to provide accurate information but
cannot be held responsible for typos or mistakes.
This quick start guide provides
only basic information on the
camera's settings and operation for
initial installation. Please read the
user manual for optimal camera
confi gurations.
Find the latest product
documentation and software.
Scan the QR code or go to
openeye.net/downloads
QUICK START GUIDE
4MP Outdoor IP Bullet
OE-C2012B4
37555AC