suprema D2 How To Configure

Hide thumbs Also See for D2:

2021/03/01 06:25

Table of Contents

- https://kb.supremainc.com/knowledge/

..............................................................................................................

................................................................................................................

...........................................................................................

How to Configure D2 Keypad

Table of Contents

Need help?

Do you have a question about the D2 and is the answer not in the manual?

Page 1 2021/03/01 06:25 How to Configure D2 Keypad Table of Contents How to Configure D2 Keypad ......................Adding as a Slave Device ........................ Using the device as a Wiegand Reader ................... - https://kb.supremainc.com/knowledge/...
Page 2 Adding as a Slave Device You will need a master device to add the slave D2 Keyapd device. Refer to the article below to learn how to search a slave device. RS485 Mode (Master, Default, Slave) If you enable the option 'Input card ID from keypad', user can authenticate by entering the card number on the D2 Keypad.
Page 3 2021/03/01 06:25 How to Configure D2 Keypad Possible key input ranges The range of numbers that can be received by the keypad is 8 bytes (0 to 18,446,744,073,709,551,615) Using the device as a Wiegand Reader If you have already used the device as a slave device before, you must reset the device to use it as a Wiegand reader (sending Wiegand output).
Page 4 2021/03/01 06:25 How to Configure D2 Keypad You cannot use the device as a slave device and use Wiegand output at the same time. From: https://kb.supremainc.com/knowledge/ Permanent link: https://kb.supremainc.com/knowledge/doku.php?id=en:how_to_configure_d2_keypad Last update: 2019/02/26 22:36 - https://kb.supremainc.com/knowledge/...