Contents Safety instructions ...................... 3 Introduction ........................5 Components..................................5 Name and function of each part ..........................6 Cables and connectors ................................7 Installation ........................8 Fixing the bracket and the product ........................8 Cable connection ................................ 10 Power supply connection ................................10 RS-485 connection ..................................
Safety instructions Safety instructions Observe the following instructions to use the product safely and prevent any risk of injury or property damage. Warning Noncompliance of instructions could lead to serious injury or death. Installation Do not install the product in a place with direct sunlight, moisture, dust, or soot. A fire or electric shock may occur.
Page 4
Safety instructions Operation Do not drop the product or apply an impact to the product. A product failure may occur. • When cleaning the product, wipe the product with a soft and dry cloth and no water, benzene or alcohol. Otherwise, a product failure may occur.
Introduction Name and function of each part LED lamp RF card authentication unit Reset button Cable Name Description LED lamp Indicates the operational status of the device with the color of the LED lamp. RF card authentication unit Reads RF cards for entering and exiting. Reset button Initialize the device.
Introduction Cables and connectors Name Color PWR +VDC PWR GND Black (White stripe) 485 TRXN Yellow (Black stripe) 485 TRXP Blue (White stripe) Green WG D0 WG D1 White LED RED Orange LED GRN Brown BEEP Purple TMPR Gray...
XPass D2 will be installed. NOTE If installing XPass D2 on a concrete wall, drill holes, insert PVC anchors, and fix them with fixing screws. • To avoid RF interference, a minimum separation distance must be maintained.
Page 9
Installation Install XPass D2 onto the fixed bracket. Wall Connect XPass D2 to the bracket by rotating the product fixing screw. Wall...
Installation Cable connection XPass D2 can be used as an RFID card reader by connecting to a master device or a CoreStation. Power supply connection XPass D2 1 - PWR +VDC 2 - PWR GND Black (White stripe) DC power NOTE •...
Installation Wiegand and other cable connections 2 - PWR GND Black (White stripe) XPass D2 5 - WG D0 Green 6 - WG D1 White 7 - LED RED Orange 8 - LED GRN Brown 9 - BEEP Purple 10 - TMPR...
FCC compliance information FCC compliance information THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Suprema's products. Do not use the product of Suprema under the situations related to medical, rescue of human lives, or maintenance of life, as a •...
Need help?
Do you have a question about the XPass D2 and is the answer not in the manual?
Questions and answers