Current Sensing Headers; External Segger J-Link™ Debug Interface - Ublox EVK-BMD-340 User Manual

Figure 9: NFC connector

2.7 Current sensing headers

The evaluation board provides two current sensing headers. "JBMD" allows for power
consumption measurement of the BMD-34 module and "JSHD" allows for power consumption
measurement of the shields connected to the Arduino-style headers ("VSHLD" power only).
Each 3-pin 2.54 mm pitch header has two pins connected across a 1 Ω current-sense resistor
powering the module or the shield, and the third pin to ground. To measure current
consumption, use a multimeter or other precision voltage measurement device to measure
voltage drop across pins one and two. Current can also be measured directly by removing
"RBMD" / "RSHD" and using a current meter in series with the two voltage pins. The default
hardware configuration does not require any modification of the current sense headers for the
BMD-34-EVAL to perform properly.
☞
Only current flowing through "VBMD" into the module is measured; current sunk through
GPIO pins is not measured.
Figure 10: Current sensing header layout
2.8 External SEGGER J-Link™ debug interface
External target hardware can be connected to J3 for firmware programming and debug. The
SEGGER debug interface is implemented as shown in Figure 10. J3 is implemented with a 2x5
10-pin header on 1.27 mm centers.
UBX-19033356 - R05
C1-Public
Hardware description
BMD-34 / 38 EVK - User guide
Page 11 of 20