Installing The Attachment Mount - Toro 79413 Operator's Manual

1. Spacer
2. Locknut (3/8 inch)
3
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1
Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
Installing the Stabilizer Bracket
and Pivot Frame
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch)
Figure 4
3. Suitcase weights
4. Bolts (5/8 x 2-3/4 inches)
(Figure 5).
g299244
1. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in
machine frame using 2 bolts (5/16 x 1 inch) and
2 locknuts (5/16 inch).
Note:
Remove the hitch bracket and hardware
if they are installed.
1. Locknut (5/16 inch)
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
6
Figure 5
2. Locknut (5/16 inch)
Figure 6. Secure the pivot frame to the
Figure 6
2. Bolt (5/16 x 1 inch)
Figure 7.
g300204
g300205