Installing The Attachment Mount - Toro 60in Bagger Kit Operator's Manual

3
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
1 Draw-bar decal
Procedure
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch) as shown in
1. Stabilizer bracket
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in Figure
pivot frame up until it is tight against the bottom
of the engine guard. Loosely secure the pivot
Figure
Figure 6
3. Locknut (5/16 inch)
7. Ensure that you push the
frame to the machine frame using 2 bolts (5/16 x
1 inch) and 2 locknuts (5/16 inch).
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
6.
1. Self-tapping screw (5/16 x
3/4 inch)
4. Tight the 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch) from step 2.
5. Attach the draw bar decal 1.3 cm (1/2 inch) to
the left of the attachment mount
g203564
8
Figure 7
4. Bolt (5/16 x 1 inch)
5. Pivot frame
Figure 8.
Figure 8
2. Pivot frame
(Figure
g203563
g203566
9).