Download Print this page

Monte Carlo Fan Company Launceton 56 4LNCR56 Series Owner's Manual And Installation Manual page 5

Advertisement

SAFETY CABLE INSTALLATION
13
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 1.5" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
16
Partially loosen one and remove one
preassembled screw from mounting
bracket. Save screw.
© 2020 Monte Carlo Fan Collections
14
Black (Live)
Power source
White (Neutral)
Ground/Green
Green/Ground
Make wiring connections using wire connectors provided as indicated above.
Red from fan to Red from remote marked Motor 1.
Purple from fan to Purple from remote marked Motor 2.
Gray from fan to Gray from remote marked Motor 3.
White (Neutral) from house to White from remote marked AC IN N.
Black (Live) from house to Black from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet box. The splices after being
made should be turned upward and pushed carefully up into the outlet box.
17
Canopy
bottom cap
Lift canopy up, aligning its keyhole slot
with the preassembled screw on
mounting bracket and twist
counterclockwise to lock in place.
Reinstall the screw removed in step 16
and tighten all screws securely.
Attach canopy bottom cap onto canopy
by aligning its notch with the screws on
mounting bracket and twist clockwise till
tight.
5
Wall Switch
Black (AC IN L)
White (AC IN N)
Red (Motor 1)
Purple (Motor 2)
Gray (Motor 3)
Receiver
1/2020

Advertisement

loading

This manual is also suitable for:

Launceton 56 4lncr56Launceton 56 4lncr56mbk