Assembly Of The Pedals - Magnum Nomad Manual

Installation & Adjustment
Step 6. Adjust the Stem Angle & Height
Use a 5mm hex key to loosen the side bolt
and then a 5mm hex key to loosen the un-
derside bolt. Adjust the stem angle to your
preferred height and then tighten the bolts.
Step 7. Check Stem
Stand in front of the bike and clamp the front
wheel with both legs. Verify the handle bars
are straight and perpendicular to the front
wheel. Then make sure that the pinch bolts
are tight and you can not turn the stem free-
ly from the front wheel (meaning the stem
should not twist separate from the front
wheel, they should only twist together).
Step 8. Adjust the Handlebar & Display
Sit on the saddle and rotate the handlebar to your desired position. Then fully tighten the four face-
plate screws to secure it. Loosen the screws on the display mount to adjust the angle. Tighten the
screws to secure the display mount in place. The angle of the display itself can also be adjusted.
2. Assembly and Adjustment

2.2 Assembly of the Pedals

Step 9. Install Pedals
The left and right pedal are marked on each end to differentiate. NOTE: It's best to grease the pedal threads
before installation. To install the pedals on the crank arms tighten the right pedal clockwise, and left pedal
counterclockwise. NOTE: Left and right are the same sides as when you are riding the bike, not facing it.
06