Assembly Of The Pedals - Magnum Scout Manual

Installation & Adjustment
Step 7. Check Stem
Stand in front of the bike and clamp the front wheel with both legs. Verify the handle bars are straight and perpen-
dicular to the front wheel. Then make sure that the pinch bolts are tight and you can not turn the stem freely from
the front wheel (meaning the stem should not twist separate from the front wheel, they should only twist together).
Step 8. Adjust the Handlebar & Display
Sit on the saddle and rotate the handlebar to your desired position. Then fully tighten the four face-
plate screws to secure it. Loosen the screws on the display mount to adjust the angle. Tighten the
screws to secure the display mount in place. The angle of the display itself can also be adjusted.
2. Assembly and Adjustment

2.2 Assembly of the Pedals

Step 9. Install Pedals
The left and right pedal are marked on each end to differentiate. NOTE: It's best to grease the pedal threads
before installation. To install the pedals on the crank arms tighten the right pedal clockwise, and left pedal
counterclockwise. NOTE: Left and right are the same sides as when you are riding the bike, not facing it.
L
06
R