Table of Contents
Advertisement
1-7) Replace the roller guide with the new-type roller guide (FL1-5052-000).
1-8) Checking the rear saddle alignment plate
1-8-1) Move the rear saddle alignment plate [1] by hands to the 2 markings (top & bottom) [2] seen on the saddle bracket. Then,
check if it is properly moved to the markings. (Marking at the top and bottom. The bottom marking is located in the center.)
[A] shows the rear saddle alignment plate in the correct position located at the markings at the top and bottom. (The bottom
marking is located in the center.)
[B] shows the skewed rear saddle alignment plate.
1-8-2) If the rear saddle alignment plate is skewed, proceed to next step. If it is in the correct position, proceed to 1-9).
1-8-3) Remove the 2 stepped screws [2] on the delivery guide unit [1].
12
Advertisement
Table of Contents
