Focusrite Red 8Line User Manual page 25

Tools Menu . . .
Device Page:
Host Mode
• Thunderbolt
Front Panel Meter Source
• Analogue I/O
• S/PDIF I/O
• ADAT 1 I/O
• ADAT 2 I/O
Output Routing Presets – Select a saved preset from the list and click "Apply Preset" to activate.
Retain +48V – On/Off state. When enabled, power settings will be restored to their previous state on
power-up.
Dante Delay Compensation (Red 8Line and Red 16Line only)
• Enable – On/Off state.
• Latency – Delays the Analogue Input and S/PDIF Input by 1 to 253 samples in order to align
with the Dante Input. Can also be entered in milliseconds.
Restore Factory Defaults – Returns the unit to its factory settings.
Setup Page:
S/PDIF Source
• RCA
• Optical
When optical is selected, it will set optical input 1
and optical output 1 to the S/PDIF format
MIDI Channel – Set the MIDI channel (1 –
16) to which the unit will respond:
• Off
• MIDI Channel 1
• MIDI Channel 2
• MIDI Channel 16
Notes:
- The default is "Off"
- 16 channels are available allowing a maximum of 16 independent Red unit control paths
- Two devices should not be set to the same MIDI channel
- MIDI channel selection is saved with the computer, not the device. Therefore, when controlling the same unit
from a different computer the MIDI channel allocation may no longer be the same
For more information, please download the MIDI Control User Guide at:
• Pro Tools
• Dante 1-8 I/O
• Dante 9-16 I/O
• Dante 17-24 I/O
• Dante 25-32 I/O
25
http://www.focusrite.com/downloads