NEC Express5800/R120e-2E User Manual page 92

Chapter 2 Preparations
1.13.4 Removal
To remove a riser card, reverse the installation procedure. Hold the card firmly and remove it. When removing
it, have another person hold the server so that the server does not move.
If needed, run SETUP utility, and then specify the boot order from the Boot menu. For details about the Boot
menu, refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
If using the server while the card is removed, attach the slot cover that comes with the riser card.
92
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the configuration
menu for RAID Controllers cannot be launched.
Express5800/R120e-2E User's Guide
1. Installing Internal Optional Devices