Rack; Installing Rack - NEC Express5800/R310g-E4 User Manual

Chapter 2 Preparations
2.2

Rack

This server must be mounted to a rack which conforms to EIA standards.

2.2.1 Installing Rack

Refer to the manual that comes with your rack for how to install the rack, or consult with your sales representative.
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, see
Safety Precautions and Regulatory Notices.

Use only in the specified environment.

Do not connect the ground wire to a gas pipe.
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, see Safety Precautions and Regulatory Notices.

Do not carry or install the server only by a single person.

Remove the CPU/IO module from the server and 4U chassis before moving
the server.

Do not install the server so that the load may be concentrated on a specific
point.

Do not install any components only by a single person.

Confirm that hinge pins of the door are completely secured in place.

Do not pull out the CPU/IO module from the rack when the rack is unstable.

Do not provide the wiring for the server to exceed the rating of the power
supply.

Do not use the server in the environment where corrosive gas is generated.
Express5800/R310g-E4, R320g-E4, R320g-M4 User's Guide
W ARNING
CAUTION
2. Installation and Connection
41