Supermicro A+ AS-1114S-WTRT User Manual page 78

A+ Server AS -1114S-WTRT User's Manual
Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits per Second
This item sets the transmission speed for a serial port used in Console Redirection. Make
sure that the same speed is used in the host computer and the client computer. A lower
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this item to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits
Parity
Stop Bits
CPU Configuration

SMT Control
Use this setting to specify Simultaneous Multithreading. The options are Disabled and Auto.
Core Performance Boost
This setting is used to configure for Core Performance Boost. Options include Auto and
Disabled.
Global C-state Control
This setting is used to configure for Global C-state Control. Options include Auto, Disabled
and Enabled.
Core Control
This sets the number of cores to be used by your system. Once this option has been used to
remove any cores, a power cycle is required in order for the future selections to take effect.
Options include TWO (1+1), Two (2 + 0), Three (3 + 0), Four (2 + 2), Four (4+0), Six (3 + 3)
and Auto. If unsure, leave this to Auto.
78