Table of Contents
Advertisement
2. Lift the riser card bracket from the chassis.
3. Install the riser card on the bracket with the two screws provided, see Figure 3-13.
4. Open the latch on the end of the bracket.
5. Install the expansion card by sliding the card into the appropriate slot in the riser card,
and then close the bracket latch over the end of it.
6. Install the entire assembly into the appropriate slot on the serverboard while aligning the
bracket in the rear of the chassis.
Figure 3-14. Installing Riser Card to Bracket
Note: Graphics in this manual are for illustration purposes only. Your components may look
slightly different.
Chapter 3: Maintenance and Component Installation
35
Advertisement
Table of Contents
