Supermicro A+ AS-1114S-WTRT User Manual page 56

A+ Server AS -1114S-WTRT User's Manual
Power Fail LED
The Power Fail LED connection is located on
pins 5 and 6 of JF1. Refer to the table below
for pin definitions.
Reset Button
The Reset Button connection is located on
pins 3 and 4 of JF1. Attach the hardware
reset switch from the computer case to this
header to reset the system. Refer to the table
below for pin definitions.
Power Button
The Power Button connection is located on
pins 1 and 2 of JF1. Momentarily contacting
both pins will power on/off the system. This
button can also be configured to function as
a suspend button (with a setting in the BIOS
- see Chapter 4). To turn off the power in the
suspend mode, press the button for at least
4 seconds. Refer to the table below for pin
definitions.
Power Fail LED
Pin Definitions (JF1)
Pin# Definition
5 Vcc
6 Ground
Reset Button
Pin Definitions (JF1)
Pin# Definition
3 Reset
4 Ground
Power Button
Pin Definitions (JF1)
Pin# Definition
1 Signal
2 +3V Standby
56