Table of Contents
Advertisement
Installing an M.2 2280 Device
1. Power down the system as described in Section 3.1 and then remove the top chassis
cover as described in Section 3.2.
2. To loosen the M.2 plastic standoff on the motherboard, lift up its top square latch, and
use gentle force to pull it out of the hole.
3. Move and place the standoff plug in the proper hole.
4. Insert the M.2 2280 device at a slight angle in the M.2 slot, and ensure the notch on the
other end of the device aligns the standoff top.
5. Pull the top square latch down and ensure the latch plug is pushed in standoff to secure
the device in place.
6. Replace the node into the chassis.
Chapter 3: Maintenance and Component Installation
41
Advertisement
Table of Contents
