Page 1
1. Disconnect frame from hopper. Save ½-13 x 3.0 stainless screws for further use. Discard ½-13 zinc plated nuts. Slide frame #3015859 into hitch receiver. Fig.1. Fig. 1 2. Slide hopper assembly #3015380 between frame uprights with front portion rested on the truck’s bumper.
Page 2
3. Align holes in rear portion of the hopper 4. Slide hopper and frame towards tailgate leaving with slots in frame uprights. Use slots which about 3/8” to ½” space. Align closest holes in hitch will position spreader horizontally or tilt it slight receiver with holes in frame.
Page 3
7. Attach shield #3015707 to trough bracket as 8. Attach spinner protector #3016672 to spreader shown in Fig.7 frame as shown in Fig.8. Fig. 7 SCREW 3/8-16 X 1.0 3016672 NUT 3/8-16 WASHER FLAT 3/8 WASHER FLAT 3/8-16 SCREW 3/8-16 X 3.5 MUT NYLOCK 3/8-16 Fig.
Page 4
THIS IS WIRE GROUND ELECTRICAL SYSTEM! NO CONNECTIONS TO TRUCK’S FRAME OR BODY ALLOWED! NOTE: Always disconnect battery before attempting to install electrical components on your vehicle. Mount the controller in a convenient location GEAR MOTOR in the truck cab. It is recommended not to mount the controller PART #3015377 directly in front of heat vents.
30 days after sure all components are included. When ordering such defect is discovered, and returned part(s) are found to be defective by Buyers Products Company. replacement or spare parts refer to parts list for Authorization from Buyers Products Company must part numbers.