Basic Finishing 4: Stone Or Brick Around S2Pf Surround - Kingsman ZCV39NE2, ZCV39LP, ZCV39LPE, ZCV39LPE2 ZCV42N Installation Instructions Manual

ZCV39 / ZCV42
Step One:
Frame Fireplace with nailing tabs oriented as
shown.
Step 3: A stone, brick, or other non-combustible border
may be applied over fireplace face to conceal border.
1-15/16" MIN
1-3/4" MIN
ZCV39
Fireplace
Opening

Basic Finishing 4: Stone or Brick Around S2PF Surround

Nailing Tab
Stone, Brick, etc.
Required
Clearance
Bottom
of Unit
Step Two: Use Drywall to finish face of wall.
NOTE: Drywall will be flush with fireplace face.
Fireplace Frame
IMPORTANT NOTE!:
If installing stone, brick, or other non-
combustible material around the perimeter of the surround:
you MUST Leave 1-3/4" of the face exposed around the
fireplace opening on the Bottom and Sides, and 1-15/16"
exposed on the top. This is to install and remove the surround.
See drawings below. A Tile Lip Kit (ZCV-TLK) is available.
Stone, Brick, etc.
S2PF Surround
ZCV42
Fireplace
Opening
Drywall
Required
Clearance
Bottom
of Unit
26